Description
| Area | Exterior |
| Recommended Use | Vertical wood surfaces in outdoor areas |
| Base | Oil-Based |
| Coverage | Up to 18m² per litre |
| Drying Time | 12 Hours |
| Re-Coat Time | 12 Hours |
| Recommended Coats | 2 Coats |
| Application Method | Brush or Roller |
Ensure the surface is clear from debris, dry and frost-free
- Clean old microporous stains thoroughly.
- Old paints and lacquers must be completely removed by sanding or using a paint stripper such as Osmo’s Paint Stripper. Do not sand smooth surfaces finer than grit P120.
- If you have weathered or greying wood it may affect the finished colour we would advise using Osmo’s Wood Reviver Power Gel prior to application.
- If additional protection against blue stain, rot and insects is desired, pre-treat the wood if possible on all sides with Osmo WR Base Coat.
Note: Fresh, especially hardwood rich in extractives needs to weather off for approximately 6 weeks after installation. Thereby the wood becomes absorbent and the oil finish adheres optimally.
Before applying the product test a small area on the surface to be treated to ensure you are happy with the finished results. Results are influenced by the condition of the wood therefore a trial application is highly recommended.
- Stir the product thoroughly.
- Apply using a brush we recommend using Osmo’s Flat Brush.
- Apply thinly evenly along the wood grain and spread well.
- Allow to dry for 12 hours under good ventilation.
- Apply a second coat as above.
Note: Always follow the manufacturer’s instructions found on the bottle.
